AbstractAbout AuthorsReferences
Based on natural and man-made raw materials from the Republic of Tyva, clinker wall materials were manufactured in laboratory conditions, the physical and mechanical characteristics and structure of which were compared with samples from foreign and domestic manufacturers. The results of the analysis of samples obtained with wall clinker from foreign factories ABC-keramik (Germany), Lode (Lithuania) and those produced in the Siberian Federal District (SFO) (LLC Likolor Brick Plant) are presented. Physical and mechanical tests showed compliance of the performance characteristics of clinker bricks with GOST 530-2012 “Ceramic brick and stone. General technical conditions”. The study of the phase composition and structure of ceramic stone revealed differences that are associated with the features of the raw materials used for the production of products. The chemical composition of clinker stone was determined, microscopic and petrographic studies of the structure were performed. It is shown that the quality and reserves of clay and technogenic raw materials in the Siberian Federal District, in particular the Republic of Tyva, make it possible to develop on a large scale the production of wall clinker products.
G.I. STOROZHENKO1, Doctor of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
I.M. SEBELEV1, Doctor of Sciences (Engineering),
T.E. SHOEVA1, Candidate of Sciences (Engineering);
T.V. SAPELKINA2, junior researcher
I.M. SEBELEV1, Doctor of Sciences (Engineering),
T.E. SHOEVA1, Candidate of Sciences (Engineering);
T.V. SAPELKINA2, junior researcher
1 Novosibirsk State University of Architecture and Civil Engineering (SIBSTRIN) (113, Leningradskaya Street, Novosibirsk, 630008, Russian Federation)
2 Tuvinian Institute for Exploration of Natural Resources of Siberian Branch of the Russian Academy of Sciences (117 A, Internacional’naja Street, Kyzyl, 667007, Republic of Tyva, Russian Federation)
1. Semenov A.A. Some trends in the development of the ceramic wall materials market in Russia. Stroitel’nye Materialy [Construction Materials]. 2022. No. 4, pp. 4–5. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2022-801-4-4-5
2. Kotlyar V.D., Uzhakhov K.M., Kotlyar A.V., Terekhina Yu.V. Clinker brick: standardization, properties, application. Stroitel’nye Materialy [Construction Materials]. 2023. No. 5, pp. 4–8. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2023-813-5-4-8
3. We are developing a strategy for the development of the construction industry until 2030. - URL: https://stroystrategy.ru (2017) - Text: electronic.
4. Sapelkina T.V., Storozhenko G.I., Shoeva T.E. Composite ceramic materials from natural and technogenic rocks of the Republic of Tyva. Stroitel’nye Materialy [Construction Materials]. 2023. No. 5, pp. 9–13. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2023-813-5-9-13
5. Kara-sal B.K., Chyudyuk S.A., Sapelkina T.V. Development of the composition of the charge based on overburden rocks of coal mining for the manufacture of ceramic wall materials. Estestvennye i tehnicheskie nauki. 2019. No. 9 (135), pp. 165–169. (In Russian).
6. Kara-sal B.K., Strelnikov A.A., Sapelkina T.V. Technological properties of ceramic masses based on argillite overburden coal mining, crushed at various grinding plants. Estestvennye i tehnicheskie nauki. 2020. No. 5 (143), pp. 122–127. (In Russian).
7. Kara-sal B.K., Chyudyuk S.A., Sapelkina T.V. Technological properties of clay overburden rocks of coal mining in the production of ceramic wall materials. Estestvennye i tehnicheskie nauki. 2018. No. 1, pp. 165–169. (In Russian).
8. Kotlyar A.V., Lapunova K.A., Lazareva Y.V. Orlova M.E. Effect of argillites reduction ratio on ceramic tile and paving clinker of low-temperature sintering. Materials and Technologies in Construction and Architecture. Material Science Forum Submitted. 2018. Vol. 931, pp. 526–531. https://doi.org/10.4028/www. Scientific.net/MSF.931.526.
9. Kara-sal B.K., Chyudyuk S.A., Irgit B.B. Features of the use of argillite overburden coal mining rocks for the production of ceramic wall materials. Vestnik of Tuva State University. Issue 3. Technical and physical-mathematical sciences. 2020. No. 2 (62), pp. 6–18. (In Russian).
10. Kotlyar V.D., Terekhina Yu.V., Kotlyar A.V., Features of Properties, Application and Requirements for Clinker Brick. Stroitel’nye Materialy [Construction Materials]. 2015. No. 4, pp. С. 72–74. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2015-724-4-72-74
2. Kotlyar V.D., Uzhakhov K.M., Kotlyar A.V., Terekhina Yu.V. Clinker brick: standardization, properties, application. Stroitel’nye Materialy [Construction Materials]. 2023. No. 5, pp. 4–8. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2023-813-5-4-8
3. We are developing a strategy for the development of the construction industry until 2030. - URL: https://stroystrategy.ru (2017) - Text: electronic.
4. Sapelkina T.V., Storozhenko G.I., Shoeva T.E. Composite ceramic materials from natural and technogenic rocks of the Republic of Tyva. Stroitel’nye Materialy [Construction Materials]. 2023. No. 5, pp. 9–13. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2023-813-5-9-13
5. Kara-sal B.K., Chyudyuk S.A., Sapelkina T.V. Development of the composition of the charge based on overburden rocks of coal mining for the manufacture of ceramic wall materials. Estestvennye i tehnicheskie nauki. 2019. No. 9 (135), pp. 165–169. (In Russian).
6. Kara-sal B.K., Strelnikov A.A., Sapelkina T.V. Technological properties of ceramic masses based on argillite overburden coal mining, crushed at various grinding plants. Estestvennye i tehnicheskie nauki. 2020. No. 5 (143), pp. 122–127. (In Russian).
7. Kara-sal B.K., Chyudyuk S.A., Sapelkina T.V. Technological properties of clay overburden rocks of coal mining in the production of ceramic wall materials. Estestvennye i tehnicheskie nauki. 2018. No. 1, pp. 165–169. (In Russian).
8. Kotlyar A.V., Lapunova K.A., Lazareva Y.V. Orlova M.E. Effect of argillites reduction ratio on ceramic tile and paving clinker of low-temperature sintering. Materials and Technologies in Construction and Architecture. Material Science Forum Submitted. 2018. Vol. 931, pp. 526–531. https://doi.org/10.4028/www. Scientific.net/MSF.931.526.
9. Kara-sal B.K., Chyudyuk S.A., Irgit B.B. Features of the use of argillite overburden coal mining rocks for the production of ceramic wall materials. Vestnik of Tuva State University. Issue 3. Technical and physical-mathematical sciences. 2020. No. 2 (62), pp. 6–18. (In Russian).
10. Kotlyar V.D., Terekhina Yu.V., Kotlyar A.V., Features of Properties, Application and Requirements for Clinker Brick. Stroitel’nye Materialy [Construction Materials]. 2015. No. 4, pp. С. 72–74. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2015-724-4-72-74
For citation: Storozhenko G.I., Sebelev I.M., Shoeva T.E., Sapelkina T.V. Prospects for the production of wall clinker in the Siberian Federal District. Stroitel’nye Materialy [Construction Materials]. 2023. No. 9, pp. 13–17. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2023-817-9-13-17