Analysis of Standardized Properties of Slag Crushed Stone Resulting From Crystal-Chemical Stabilization

The shortage of high-quality stone materials for road construction requires the search for alternative materials, the use of which will ensure the proper quality of road pavements. Metallurgical slags are a valuable raw material for the construction industry in general and for road construction in particular due to its properties. However, they are characterized by heterogeneity of composition in different batches and, as a result, physical and mechanical characteristics that change over time. The use of various methods for stabilizing that kind of technogenic raw materials makes it possible to obtain stone raw materials with specified properties. The paper considers the effect of crystal-chemical stabilization of slag in the process of draining on the complex of standardized indicators of the final material – slag rubble. Stabilization of furnace slag during draining made it possible to improve the following standardized indicators: compressive strength grades from 800 to 1200, abrasion grades from IV to II, structural stability of slag against decay from StS2 to StS1, frost resistance to F50. The physical and mechanical properties of the resulting stone material make it possible to use it for the construction of base layers and as part of composite materials for the construction of coatings in road pavement structures.

A.N. BODYAKOV, Senior Lecturer (This email address is being protected from spambots. You need JavaScript enabled to view it.),
I.Y. MARKOVA, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
V.V. STROKOVA, Doctor of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
D.O. BONDARENKO, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
E.N. GUBAREVA, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.),
A.I. BUKOVTSOVA, Candidate of Sciences (Engineering) (This email address is being protected from spambots. You need JavaScript enabled to view it.)

Belgorod State Technological University named after V.G. Shukhov (46, Kostyukova Street, Belgorod, 308012, Russian Federation)

1. Agamov R.E., Goncharova M.A., Mraev A.V. Steelmaking slags as an effective raw material in road construction. Stroitel’nye Materialy [Construction Materials]. 2023. No. 1–2, pp. 56–60. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2023-810-1-2-56-60
2. Babkov V.V., Nedoseko I.V., Glazachev A.O., Sinitsin D.A., Parfenova A.A., Kayumova E.I. Composite materials for road construction based on waste from the chemical and metallurgical industries. Stroitel’nye Materialy [Construction Materials]. 2023. No. 1–2, pp. 88–94. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2023-810-1-2-88-94
3. Kudrin V.A. Metallurgical slag is a new material. Use. Materialovedeniye. 2015. No. 1, pp. 11–14. (In Russian).
4. Yudina L.V., Yudin A. Metallurgicheskiye i toplivnyye shlaki v stroitel’stve [Metallurgical and fuel slags in construction]. Izhevsk: Udmurtia. 1995. 160 p.
5. Rakhimov R.Z. Ecology, metallurgy, mineral binders and building materials industry. Stroitel’nye Materialy [Construction Materials]. 2022. No. 9, pp. 26–31. (In Russian). DOI: https://doi.org/10.31659/0585-430X-2022-806-9-26-31
6. Goncharova M.A., Bondarev B.A., Korneev A.D. Crystalline metallurgical slags in road construction. Stroitel’nye Materialy [Construction Materials]. 2009. No. 11, pp. 23–25. (In Russian).
7. Valuev D.V., Gizatulin R.A. Tekhnologii pererabotki metallurgicheskikh otkhodov: uchebnoye posobiye [Technologies for processing metallurgical waste: a textbook]. Tomsk: National Research Tomsk Polytechnic University. 2013. 191 p.
8. Bulatov K.V., Gazaleeva G.I. Prospects for the development of technologies for processing waste from ferrous metallurgy. Fundamental research and applied development of processes for processing and utilization of technogenic formations: proceedings of the V Congress with international participation and the Conference of Young Scientists «TECHNOGEN-2021». Ekaterinburg. 2021, pp. 21–33. DOI: 10.34923/technogen-ural.2021.60.16.003
9. Yusupkhodzhaev A.A., Valiev Kh.R., Khudoyarov S.R. Pererabotka vtorichnykh tekhnogennykh obrazovaniy v chernoy metallurgii. [Processing of secondary technogenic formations in ferrous metallurgy]. Tashkent: Tashkent State Technical University. 2014. 138 p.
10. Pugin K.G., Vaisman Ya.I., Yushkov B.S., Maksimovich N.G. Snizheniye ekologicheskoy nagruzki pri obrashchenii so shlakami chernoy metallurgii [Reducing the environmental load when handling ferrous metallurgy slags]. Perm: Perm National Research Polytechnic University. 2008. 315 p.
11. Bodyakov A.N., Meshkova K.V., Dukhovny G.S. Stabilization of metallurgical slug from arc steel-making furnaces. IOP Conference Series: Materials Science and Engineering. 2020. Vol. 945. No. 1, pp. 012082. DOI: 10.1088/1757-899X/945/1/012082
12. Patent RF 2752914 Sostav i sposob stabilizatsii raspadayushchikhsya metallurgicheskikh shlakov [Composition and method of stabilization of decaying metallurgical slags]. Dukhovny G.S., Evtushenko E.I., Rubanov Yu.K., Bodyakov A.N., Deev V.V., Bondarenko S.N. Appl. 07/29/2020. Publ. 08/11/2021. Bull. No. 23.
13. Bondarenko S.N., Bodyakov A.N., Lebedev M.S. Metallurgical waste recycling for transport construction. Proceedings of the International Conference Industrial and Civil Construction. 2021. pp. 79–84. DOI: https://doi.org/10.1007/978-3-030-68984-1_12
14. Bodyakov A.N., Markova I.Yu., Logvinenko A.A., Botsman L.N., Ogurtsova Yu.N. Properties of metallurgical slag stabilized in industrial conditions. Regional’naya arkhitektura i stroitel’stvo. 2023.No. 2 (55), pp. 44–51. (In Russian). DOI: 10.54734/20722958_2023_2_44